nachdem heute keine Programme mehr ausgeführt wurden, habe ich versucht das Webif aufzurufen. Hier erscheint nur noch das Boot Logo (Homematic CCU2 ist noch nicht bereit).
Installiert ist Yahm 1.8 mit CCU2 Firmware 2.29.22
Ein Neustart des Container brachte auch keinen Erfolg, es erscheint weiterhin nur das Bootlogo. Hier der Log:
Code: Alles auswählen
Requesting system reboot
LED Code: System start: spidev
ic200_spi
spi_eq3_gpio
spi_bitbang
mknod: spidev0.0: File exists
gpio-keys
fsl_usb2_udc.ko
tun
ehci-hcd
mxs_raw_auart
eq3_char_loop
OK
Init Firewall: Starting crond: OK
crond[47]: crond: crond (busybox 1.20.2) started, log level 8
Starting logging: OK
Populating /dev using udev: <30>udevd[56]: starting version 182
done
Starting watchdog...
Initializing random number generator... done.
Starting network...
ip: RTNETLINK answers: File exists
sysctl: error: 'net.ipv4.tcp_timestamps' is an unknown key
udhcpc (v1.20.2) started
Sending discover...
Sending select for 192.168.1.35...
Lease of 192.168.1.35 obtained, lease time 864000
rm: can't remove '/var/etc/resolv.conf': No such file or directory
udhcpc (v1.20.2) started
Sending discover...
Sending select for 192.168.1.35...
Lease of 192.168.1.35 obtained, lease time 864000
Starting Network Interface Plugging Daemon: eth0.
Preparing start of hs485dOK
Starting setclock: ntp.homematic.com not found
try gateway 192.168.1.1
GATEWAY not found
OK
Starting eq3configd: OK
Starting lighttpd: OK
Starting lighttpd with SSL support: OK
ls: /etc/config/*.keychange: No such file or directory
OK
Starting hs485d: OK
Starting multimacd:
Could not open SPI device: No such file or directory
Could not open SPI device: No such file or directory
sed: /sys/module/plat_eq3ccu2/parameters/radio_mac: No such file or directory
2017/10/29 12:21:17.234 <Error> CCU2CommControllerMod::performIdentify(): Unable to determine coprocessor state.
Could not open SPI device: No such file or directory
firmware update disabled
Waiting for multimacd to get ready.sh: 411: unknown operand
.sh: 411: unknown operand
.sh: 411: unknown operand
.sh: 411: unknown operand
.sh: 411: unknown operand
Timeout while waiting for multimacd to get ready.
Starting rfd:
Waiting for rfd to get ready.sh: 438: unknown operand
.sh: 438: unknown operand
.sh: 438: unknown operand
.sh: 438: unknown operand
.sh: 438: unknown operand
.rfd is ready now.
Starting HMServer: cp: can't stat '/etc/config_templates/hmip_networkkey.conf': No such file or directory
Waiting for HMServer to get ready
OK
Starting ReGaHss: OK
System startedOKHat jemand eine Idee?
!!! 